BEAD/SEQUIN FOOT # A1A283000

This special sewing foot is for sewing on beads, sequins, pearls, strass bands, strings and ordinary cords, these operations are carried out with one needie.

Set differential feed at "N" position. Insert bead sewing foot. For small beads use the right needle. For large beads use the left needie. Push the bead tape throught guides 1 and 2 to the end of the foot ( Fig. 1 ). For all seam width settings it is possible to workd wilh or without upper knile; guide the fabric along the righthand sewing foot edge. Stitch length:3 to 4. Ascertain correct thread tension by making a test seam.

Note:

if the bead tape is sewn onto the fabric edge, the left needle must be used ( disengage upper knife ). The needle should penetrate at about to 1.5mm from the fabric edge ( Fig. 2 ).